Faber MAES36SS Installation Manual download pdf (Page 6)

Version 05/11- Page 6

PREPARE THE WALL

1. Disconnect and move freestanding range from cabinet

opening to provide easier access to upper cabinet and rear

wall. Put a thick, protective covering over cooktop, set-in

range or countertop to protect from damage or dirt.

2. It is recommended that the vent system be installed

before hood is installed. Before making cutouts, make sure

there is proper clearance within the ceiling or wall for exhaust

vent. Check that all installation parts have been removed

from the shipping carton. First, disconnect power.

Then determine which venting method to use: roof, wall

or rear exhaust.

CHANGING HOOD TO OPTIONAL REAR EXHAUST

The hood comes from the factory with the exhaust

collar on top of the hood. The hood exhaust may be directed out the rear of

the hood through the exhaust collar. If you desire to have the hood exhaust

out the rear, follow the procedure below.

1. From inside the hood, unplug wire attached to blower motor.

2. Turn the hood over and remove the screws holding the exhaust blower

assembly to the hood.

A. Blower Motor

B. Blower motor plug

A. Blower Motor

B. Screws

3. Rotate the blower assembly so that the exhaust collar is

facing out the back of the hood.

4. Replace the screws holding the blower assembly

to the hood.

5. Plug the blower motor wire back into the blower

motor.

RANGE HOOD MOUNTING SCREWS INSTALLATION

The hood attaches to the wall with two mounting brackets

with adjustment screws and four mounting screws.

1. Determine and mark the centerline on the wall where

the canopy range hood will be installed.

2. Select a mounting height between a minimum of 30"

and a suggested maximum of 36", above the

cooking surface and the bottom of the range hood. To this

distance, add 16" and mark a horizontal line.

3. Mark 2 points on each side of the horizontal line the

distance shown in “A” below (based on the size of your

range hood).

A: Distance from center of mounting bracket to centerline:

30" hood: 13 3/8" / 36" hood: 16 3/8" /

42" hood: 19 7/16" / 48" hood: 22 3/8"

B: Mounting Screws (4)

C: Mounting brackets and adjustment screws

D: Bottom of hood

4. Adjust the two adjusting screws on the mounting brackets

to the lowest point and attach to the wall with the screws

provided. The screws provided for mounting this hood must

be fastened into solid wood. Do not fasten into sheet rock

only.

A. Exhaust blower assembly

B. Screws

C. Exhaust collar

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Comments to this Manuals

No comments

Faber MAES36SS Installation Manual Page 6

Comments to this Manuals

Related products and manuals for Cooker hoods Faber MAES36SS