Faber Remote Blower User Manual

Instruction ManualREAD AND SAVE THESE INSTRUCTIONSThe Installer must leave these instructions with the homeowner. The homeowner must keep these instru

10 ENREAR AIR OUTLET CONFIGURATION• Remove the suction panel by unfastening the 8 screws around the frame.• Remove the metal grease filters.• Remove t

11ENHood body installation• In case of the bottom air outlet configuration the hood body has to be turned180°.• Remove the top cover of the terminal b

12 ENLighting unit installation• Provide for passage of the electrical connection wires with the hoodbody.• Slide the top cover downwards, unfastening

13ENElectrical connectionELECTRICAL SHOCK HAZARD• Disconnect power before making electrical connctions.• Connect ground wire to green ground screw in

14 ENMAINTENANCEGrease filtersCLEANING METAL GREASE FILTERS•Alarm signal reset• Switch off the lights and extractor motor.• Press button T3 for at lea

15ENElectric DiagramLightingLIGHT REPLACEMENT20 W halogen light.• Extract the lamp from the Support.• Replace with another of the same type, making su

436002499_02 - 041103

2 ENCONTENTSWARNING 3CHARACTERISTICS 5INSTALLATION 8USE 13MAINTENANCE 14

3ENREAD THESE INSTRUCTIONS BEFORE YOU START INSTALLING THIS RANGEHOODREAD AND SAVE THESE INSTRUCTIONSWARNING: - TO REDUCE THE RISK OF A RANGE TOP GREA

4 ENThis appliance should be connected directly to the fused disconnect (or circuit breaker) through flexible, armored or nonmetallic sheathedcopper c

5EN134510111213GEFDCA2CHARACTERISTICSComponentsQ.ty1 1 Hood Body, complete with: Blower, Filters, Controls2 1 Built-in hood body case3 1 Rear remote

6 ENDimensional chart - HoodDistance fromthe Hob

7ENDimensional chart - LIGHT

8 ENINSTALLATIONThe hood can be installed in the following ways: top air outlet, bottom air outlet, rear air outlet. Once the desired configuration ha

9EN LIGHTING UNIT INSTALLATION SCHEMELIGHTING UNIT LOWER BORDER SHALL BE INSTALLED AT THE MINIMUM DISTANCE OF 34 9/16 IN. ABOVE THE COOKING SURFACE.Wi