Faber CRISTAL HC User Manual download pdf (Page 7)

Version 09/12 - Page 7

USE AND CARE INFORMATION

Rangehood Control Panel

All controls are located on the right side of the rangehood.

Light On/Off Switch

TheOn/Off switch for the uorescent light is located behind the

front trim. Moving the switch to the 1 Position turns the light

On. Moving the switch to the 0 position turns the light off.

Blower Speed Switch

B in FIGURE 10 shows the speed control switch for the

blower. Moving the switch to the 1 Position turns the blower

on LOW. Moving the switch to the 2 Position turns the blower

on MEDIUM. Moving the switch to the 3 Position turns the

blower on HIGH. Moving the switch to the 0 Position turns

the blower off.

Automatic Operation

As long as the blower and light switches are on, the blower

and light will automatically operate when the visor is opened

and shut off when the visor is closed.

For Best Results

Start the rangehood several minutes before cooking to develop

proper airow. Allow the unit to operate for several minutes

after cooking is complete to clear all smoke and odors from

the kitchen.

Cleaning

The metal grease lters should be cleaned frequently in hot

detergent solution or placed in the dishwasher. Clean exterior

surfaces with hot soapy water. Using abrasives and scouring

agents can scratch rangehood nishes and should not be

used to clean nished surfaces.

Replacing the Fluorescent Light

USE CAUTION AS THE BULB MAY BE HOT

To replace the uorescent light, remove the diffuser clips from

both ends of the glass diffuser (L in FIGURE 10) by removing

the screws. Carefully slide the glass diffuser all the way to the

right. Lower the left end of the glass below the support ange,

then remove the glass by sliding it back to the left. Replace

the diffuser glass by reversing these directions.

FIGURE 10

FRONT TRIM OPTIONS

The Cristal HC comes with a white front strip installed. Optional

black and brushed aluminum strips are included in the box. To

change the front strip, remove the three phillips screws located

behind the strip (FIGURE 8). If necessary, the front strip can

be adjusted by loosening the three phillips screws and sliding

the strip up or down. Tighten screws when you have the strip

properly placed.

For a custom front strip, a local cabinet shop can make a strip

to match your cabinets. The front strip dimensions are given

in FIGURE 9.

FIGURE 8

1 15/32"

FIGURE 9

3/4"

29 7/8" or 35 7/8"

Visor

Front

Strip

Three Screws

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Faber CRISTAL HC User Manual Page 7

Comments to this Manuals

Related products and manuals for Fans Faber CRISTAL HC